Embossing Plates
These plates are made of a high impact fiberglass reinforced polyurethane. We originally started making these plates to use on short runs where we only needed a few hundred impressions BUT we soon discovered that they were outlasting any of the plates made of printers metal and have much greater detail than most cast metal plates.
The samples were made using a 12 ton hydraulic shop press which is more than sufficient for plates of this size or even slightly larger.
This plate is not a hammer stamp and should be pressed in using a hydraulic press, clicker press, or a shop press like we do but the pressure plate must cover the entire top of the plate or if you are using a ram press a heavy piece of flat steel sufficient to cover the entire top of the emboss plate will be necessary.
